2015/05/03

All Ethernet-DMX

Output Box

Related products : 

In  this  setup,  the  related  products  will  be  used  as  single  output boxes (Ethernet  to  DMX)  connected  to  any  kind  of  ArtNet  source  (lighting software, lighting desk, media server...).


Artnet Controller
iControl Electronics Co., Ltd
www.icontrol.com.vn


Connect your Ethernet-DMX device to its ArtNet source. Use a cross-cable if you connect your Luminex device directly to the ArtNet source.

Be  sure  your  Ethernet-DMX  device  is  set  with  an  IP  address  within  the same IP range as the ArtNet source. Usually ArtNet devices use 2.x.x.x or 10.x.x.x IP addresses.
All Luminex Ethernet-DMX product can be set either from the front end or through  the  built-in  Web  server.  If  your  ArtNet  source  does  not  have  a Web  browser,  set  your  Luminex  device  from  the  front  end  ,  either  by loading a complete “output” profile or by setting each outlet one by one with the desired universe addresse and mode.
If you're able to reach the built-in Web server of your Luminex device, you should see Illustration 2: Loading an "All out 0" profile examples of output configurations, which is achieved by loading an output profile (All OUT 0) or you will see Illustration 3: Setting all outlets separately by setting all outlets separately.


ArtNet Controller
iControl Electronics Co., Ltd
www.icontrol.com.vn



ArtNet Controller
iControl Electronics Co., Ltd
www.icontrol.com.vn


Related products : Ethernet-DMX(2/M, 2MkII, 4MkII, 4 Truss MkII, 8MkII)
In  this  setup,  the  related  products  will  be  used  as   single  input  boxes (DMX to Ethernet). The Luminex device will convert DMX signal to ArtNet protocol  in  order  to  control  a  video  Media  server  or  any  kind  of  ArtNet devices (see Illustration below).


ArtNet Controller
iControl Electronics Co., Ltd
www.icontrol.com.vn


Connect your Ethernet-DMX device to the DMX source with a male gender adaptor  .  This  example  show  the  use  of  one  single  DMX  line,  but depending of  the Luminex device you're  using,  you can  convert UP to 8 DMX lines to Ethernet.
Be sure your Ethernet-DMX devices is set with an IP  address within the same IP range as the ArtNet device to control. Usually ArtNet devices use 2.x.x.x or 10.x.x.x IP addresses.
All Luminex Ethernet-DMX product can be set either from the front end or through the built-in Web server. If the  ArtNet device you wish to control does  not  have  a  Web  browser,  set  your  Luminex  device  from  the  front end , either by loading a complete “input” profile or by setting each outlet one by one with the desired universe addresse and mode.
If you're able to reach the built-in Web server of your Luminex device, see below  2 examples of input configurations , realized by loading an input profile (Illustration 5) or by setting all outlets separately (Illustration 6).


ArtNet Controller
iControl Electronics Co., Ltd
www.icontrol.com.vn


ArtNet Controller
iControl Electronics Co., Ltd
www.icontrol.com.vn


0 comments:

Post a Comment

 

ArtNet Controller DMX © 2015 - Designed by Templateism.com, Plugins By MyBloggerLab.com